Greek Keyboard Stickers w/ White Letters Reverse Print

Greek Keyboard Stickers High quality transparent reverse print keyboard stickers with White  Letters Instructions for installing Keyboard Stickers Keyboard stickers are designed to rugged and  durable, but the installation tips on this page can make the installation  easier and assure you of many years of trouble free service from your  overlays. You can use tweezers or a knife blade to  simply place the overlays on the key, but you must make sure that the  overlay is straight when you place it. The adhesive is designed to bond  tightly when pressed on the key. If you have to remove the overlay to  reposition it, the adhesive bond will not be as strong. The simple steps below can make placing the  overlays easier and more accurate. Before you begin installing your  keyboard stickers, you should collect the items you will need to  complete the installation: The overlays A small bowl or bottle cap with a  little water Dish washing detergent (or similar  liquid soap) A paper towel (or cotton balls) One or more Q-Tips (or cotton  balls) Tweezers or a knife blade is  recommended Step 1 Turn off your computer. It is not  necessary to disconnect the keyboard from the computer, but you  should have the computer turned off. Mix a drop of dish washing detergent  in the bowl of water. Dip the Q-Tip in the water to moisten it. Step 2 Place the Q-Tip on the paper towel to  remove the excess moisture. Step 3 Wet the computer key for the overlay.  Make sure that you do NOT place too much water or moisture on the  key. You do not want the water to run down the sides of the computer  key. CAUTION: Do not apply too much  moisture to the key. Apply only enough to make the key top moist. If  you apply too much moisture, it may drip down the side of the key  and damage the key switch. Step 4 Use a knife blade or tweezers to lift  the overlay from the sheet. Place it over the key making sure that  it is the correct key for that overlay. When you have it in place,  press the overlay onto the key. Because the key is moist, the overlay  will not immediately stick to the key allowing you to slide the  overlay slightly on the key for perfect alignment. Step 5 When you have the overlay in the  correct position, take the paper towel and press it firmly on the  overlay. This step forces any excess moisture out from under the  overlay. When the overlay is firmly in place, burnish it down with  your finger, the dry end of a Q-Tip, or your fingernail. Press  firmly enough to ensure a good bond, but not too hard as to damage  the key switch. This process will assure you a firm installation  that will last for years. View all of our  products at our e b a Y AramediA Store

Returns Accepted for this item if it's within 30 Days